top of page
Forum Posts
Omar Samy
Jun 03, 2021
In General Discussions
still got only right front shoulder and knee and left back shoulder and knee are the only ones are calibrating to zero angle and none of them all are responding to c " servo pin" " joint angle" function after those servos calibrated i've tried many tests but still same result any thoughts ? some other problems got solved like servos constent reviewed with codes in my older posts servos mg996r battery 18650 unprotected
0
4
97
Omar Samy
May 27, 2021
In General Discussions
here are the results of benchmarking the servos mg996r runs at 1.8 Hz with servo range with 130 at min 771 and max 2193 works perfectly expect some servos are trempling and got only two legs in a x shape are calibrating and set to zero so now i have to find what is the problem here
1
0
63
Omar Samy
May 12, 2021
In General Discussions
i'm using MG996R servos and set the min pwm factor at 771 and max at 2193 as shown in screen and wondering is that values is ok or not ps : i did get this values from this doc . Servo pulse width range with Arduino – Project Gus
0
2
70
Omar Samy
May 01, 2021
In General Discussions
the buzzer doesn't respond to the fdti or the power and also the board doesn't respond to the reset button . only the blue and the yellow led are lighting .
0
5
133
Omar Samy
Apr 30, 2021
In General Discussions
In file included from sketch\OpenCat.h:85:0, from D:\project data\2021\GEN CODE\OpenCat\WriteInstinct\WriteInstinct.ino:2: C:\Program Files\WindowsApps\ArduinoLLC.ArduinoIDE_1.8.42.0_x86__mdqgnx93n4wtt\hardware\arduino\avr\libraries\Wire\src/Wire.h: In member function 'void Motion::loadDataFromI2cEeprom(unsigned int&)': C:\Program Files\WindowsApps\ArduinoLLC.ArduinoIDE_1.8.42.0_x86__mdqgnx93n4wtt\hardware\arduino\avr\libraries\Wire\src/Wire.h:68:13: note: candidate 1: uint8_t TwoWire::requestFrom(int, int) uint8_t requestFrom(int, int); ^~~~~~~~~~~ C:\Program Files\WindowsApps\ArduinoLLC.ArduinoIDE_1.8.42.0_x86__mdqgnx93n4wtt\hardware\arduino\avr\libraries\Wire\src/Wire.h:65:13: note: candidate 2: uint8_t TwoWire::requestFrom(uint8_t, uint8_t) uint8_t requestFrom(uint8_t, uint8_t); ^~~~~~~~~~~ Sketch uses 24946 bytes (77%) of program storage space. Maximum is 32256 bytes. Global variables use 1380 bytes (67%) of dynamic memory, leaving 668 bytes for local variables. Maximum is 2048 bytes. -- consdering that i installed the ch341ser and configerd the FTDI uploader manully in the device maneger and the only port i get is "COM3" nyboard v1_0
0
14
159
Omar Samy
More actions
bottom of page