This shouldn't be so hard. I cannot get UI.exe to work. I get Errno 2 error no such file or directory: '.\\resources\\Bittle0_Wire.jpeg' It appears to be connected on com3. I downloaded and extracted the files in the downloads directory. Any suggestions?
Over the past few years, Rentforevent has been my go-to for all event needs in LA. They offer everything from AV equipment to staging, and their service is consistently top-notch. I can’t recommend them enough for their reliability and attention to detail. Check out their website at https://rentforevent.com/la/ My tip: make use of their consulting service to optimize your setup—you’ll end up saving time and getting better results.
I did initially moved entire folder initially and had the problems, when I moved it back to it's original folder, it still didn't work. I got it working by deleting everything that was written after the install, log, .config, etc. even anything in the registry then reinstalling. It worked fine after that. Lesson learned, if all else fails, read the directions.😀
Hi,
After extracting the files, make sure not to move the exe from its original folder.
I also noticed that your firmware version is B02_231206. Please upgrade to the lastest one using the firmware uploader or Arduino IDE to see if the problem persists.