Hello,
For my project I am using like 3 types of servo motors: 5 x SG90 with 180 degrees, 2 x SG90 with 360degrees, 4 x MG90 with 180 degrees.
Currently, the 360 degree servos just keep spinning and spinning during calibration, while the others are not doing much, they just fix themselves a bit.
How do I make sure each gets calibrated correctly and in tune with the pins they are using on the board?
I tried playing with the PCA9685servo.h code and created variables of class ServoModel but I don't quite understand how to use it in calibration and match the models with the pins.
Excellent information on servo motor models! They are actually quite important in automation and robotics. My friend and I were just talking about how industries may be revolutionised by precise control systems, such as those found in servo motors. In a similar vein to how halloween jackets bring flare to our clothing, it's fascinating how technological advancement can stimulate creativity.