I have a problem i tried programming my Bittle pre configured, Board version 1.1 with https://ide.tinkergen.com/
with this routine :
After this my robot emits the usual melody when switched on, but it starts to move its limbs in jerks and freezes, no longer recognising the input from the remote control and the phone, if I insert the serial board it emits a fixed sound.
do I have to upload the firmware again? Or how can you help me?
Thank you
installed firmware, performed calibration but now the robot does not lift when I switch it on
Thank you, i solved it by re-installing the firmware
Hi, the robot's joints have to be rotated in normal directions when turned on. Otherwise, it may rotate in the opposite direction and collide with the body. The servos may get stuck and get damaged.
You can use these methods to recover the default programs.
If you are using CodeCraft, you will need its built-in firmware writer to revert the system to the previous one. Otherwise, the skills' addresses may mismatch and cause errors.