After adding a new skill, I commented out MAIN_SKETCH and uploaded it again.
Reset joint offsets? (Y/n): pressed y and clicked Calibrate the IMU? (Y/n): I pressed n and then uncommented MAIN_SKETCH again and uploaded it.
After that, I pressed c to correct it, but as shown in the video, if I pressed s to save it and then pressed c again, a different posture appeared.
Also, if you try to calibrate again from the posture shown when you press c, it will return to the corrected posture.
It is not saved again after that
The video cannot be uploaded because it is too large. Please send me your email address and I will send it to you.
Help me
I’ve had a similar experience while working on my dissertation. After adding a new skill, I faced some issues with the MAIN_SKETCH. I tried resetting joint offsets and calibrating the IMU, but the postures kept changing. It felt like I was stuck in a loop, much like when I was seeking dissertation help services for my research. I have a video demonstrating the issue but it’s too large to upload here. If you provide your email, I’d be happy to share it with you.