I am very confused about a lot of things and im hoping there are some answers. the first question I have is soldering mandatory? can you finish without soldering? if not what do I need to solder and where. also where do I plug in the ultra sonic sensor? how do I plug in the battery pack to the nyboard? how do I connect the controller? and also a basic understanding of where to start with uploading the code in an easy way. I know im asking for a lot but honestly I know nothing about coding and I REALLY didn't know what I was getting into when I bought this. nevertheless I am VERY excited for the end product and I hope I can figure it out. if anyone is willing to answer this rather long list of questions thank you so much and I hope I can finish this. thanks. (FYI I have the Nyboard VO,2. I have not attached my raspberry pi. also I have downloaded everything from GitHub and I connected my nibble to my computer. I also downloaded Arduino sketch. I just need to know what to do from there.)
top of page
bottom of page
I'm attaching some pictures here for your convenience. Most of your questions can be answered by reading the instruction doc.
1) the first question I have is soldering mandatory? can you finish without soldering?
Soldering is not mandatory to make the cat walk.
2) if not what do I need to solder and where. also where do I plug in the ultra sonic sensor?
Ultrasound wiring is not mandatory.
3) how do I plug in the battery pack to the nyboard? how do I connect the controller? and also a basic understanding of where to start with uploading the code in an easy way.
I really need help with this please!