Hi,
I just started playing with my bittle and for a few days all was well.
My bittle stopped responding to commands on the remote control or serial monitor. I tried to upload WriteInstinct.ino and saw no errors, the Arduino IDE reports "Done uploading.". However, I did not get prompted for calibration, etc.
I can upload Opencat.ino without issues also, the only thing that appears on the serial monitor is "* Start" but bittle still does not respond to commands.
Uploading other code (testSevenRgbLED.ino) works fine.
Any help would be appreciated!
Zeus
I see. The OLED connects to the I2C network and interrupts the MPU's bootup routine. Unless you explicitly add the initialization code for the screen, you cannot plug it directly to the board running the original OpenCat code.