The piece I have that connects the two shoulders (https://youtu.be/B8N2KAf8p28?t=34) have two holes on either side of the wood, not two and three like in the part photo in the assembly instructions (see below). That makes it shorter and not long enough to reach. If I got the wrong size shipped, how do I get right size?
Y1 should enter the flat slot on the shoulder piece, not the tilted slot.
Do you have an example photo you could post of how the connection should look with the symmetric shoulder piece?
Im having similar issues not sure how to make it fit just right. Can't push the servos all the way in and the y pieces don't feel locked in. Here is a picture for reference
Please help me I'm stuck!
The difference between the two videos are just the pink shoulder piece and the number of holes on y1. Neither of them would affect assembling. The video with my instruction shows where the wires go.
The animation is different from the video of you putting it together. Are there instructors for the pieces that match the set I was sent? The videos I've seen don't include where the wires should go.
The servos should be pushed into the dents on y1 to lock all the pieces.
BTW, you are inserting the servos in the opposite direction. The shafts should be on the lower side.
It’s a puzzle. Observe the animation to find where the pink piece (the special shoulder piece) should go.
But the pieces that hold the servos at the end don't match your video. The wood with the battery on it is too narrow for the piece it gets attached to. See photos.
No, it’s not a wrong piece. The 3-hole shoulder connector in picture was an older version. I made it symmetric to reduce confusion. The way you put up the shoulder group is wrong. The side with servo’s shaft should face up.