Hi, it was a lot of fun putting the nybble together. I have everything up and running and the servos aren't working at all. I have the V1_0 board. I am wondering if the wiring is right. (Ground, + and -)
The switch is set to Arduino. I did not see a way to do the calibration.
I changed the * on#define NyBoard_V*_* in Instinct.h to match my NyBoard’s version.
Then the three "Y" and then I save it.
In the serial monitor, I type ‘c’ to enter calibration mode. Serial console:
16:12:09.035 -> 0 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15
16:12:09.035 -> 0, 0, 0, 0, 0, 0, 0, 0, 0, 0, 0, 0, 0, 0, 0, 0,
16:12:09.035 -> c0, 0,
None of the servos move.
I type ‘d’ to enter calibration mode. Serial console: nothing, but it makes a click sound.
It was a smooth build/install up until now.
Not sure what to do,,,,,,
solved. The wires for the V1_0 board were reversed, going into the board. Starting from the board, it is BROWN, RED and then YELLOW.
It would help if you included a photo of the wire color setup for the V1_0 board. The photo you posted can be read incorrectly. cheers