Just got my kit today - excited!
Wires scare me.
I've got the NyBoard V0_2 board, a 4-wire cable, a 1x4 header and a 2x5 header. Does anybody have (or can you point me to) a picture of what these parts look like when soldered together? Page 8 of the assembly instructions sound like I should solder the ultrasound board to the NyBoard but.. that doesn't sound correct?
It's gotta be that I solder the 1x4 header to the NyBoard then use the cable.. Right? Not sure which side of the board to solder them to, though - a couple pictures would be very helpful. Electronics are really not my thing.
Thanks!
The 4-pin should point up on the opposite side of servo pins. You don't have to solder it for motion.