Just got my kit today - excited!
Wires scare me.
I've got the NyBoard V0_2 board, a 4-wire cable, a 1x4 header and a 2x5 header. Does anybody have (or can you point me to) a picture of what these parts look like when soldered together? Page 8 of the assembly instructions sound like I should solder the ultrasound board to the NyBoard but.. that doesn't sound correct?
It's gotta be that I solder the 1x4 header to the NyBoard then use the cable.. Right? Not sure which side of the board to solder them to, though - a couple pictures would be very helpful. Electronics are really not my thing.
Thanks!
Excellent. TY.
What about the 2x5 block? It seems like that can only go in H1, also on the opposite side of the servo pins.
The 4-pin should point up on the opposite side of servo pins. You don't have to solder it for motion.
https://github.com/PetoiCamp/OpenCat/raw/master/Resources/Nybble_SolderingUltrasound.pdf