I have Nybble assembled and wiring done- when I connect to my computer a blue light at the connection point and on the head illuminates and a cheery tune plays- however the cat does not respond to the commands on my computer ( stand or calibrate) nor does Nybble respond to the remote ( other than beeping when I press a remote button) - any suggestions - btw my nybble board is V1-2, I have the connections positioned so that the brown ( +) sides are closest to the board ( but did try them in the other orientation with no luck) - any suggestions as to what I am doing wrong would be much appreciated!!
top of page
bottom of page
Hi again - my Nybble seems to have died- yesterday it responded to the remote / today nothing - when I connect to the computer via usb ( Mac with Big Sur OS) there is no response from nybble- I am attaching a short video of Nybble and what happens when I try to turn it on / I eventually get a short red flashing light on the battery but Nybble doesn’t start up…
Thanks - I will spend more time troubleshooting - but time for dinner first!
Please refer to the Connect Wires in the user manual to double check:
Then do Calibration and Play with Nybble.
If you still have problem, please send some short video attachments.
What's your battery? Is it turned on and connected? If it's the li-ion battery pack, you need to long-press the button to turn it on/off. The yellow LED on the main board should light up.
Could you take a picture or video to show your testing situation?