I need help with the configuration aspect for Nybble.
I can't seem to get output from my serial monitor (it just draws blank) and my Cat makes a weird noise, that's it. (I have Nyboard V1_0)
I've done everything I possible can, included all the libraries, made sure the switch is on Arduino.
This cat, every-time I use the TestBuzzer, like I will compile and upload, does nothing up until I reset the board then the buzzer goes. I guess it's the same for the WriteInstinct.ino, when I compile and upload nothing happens up until I restart the board, and it makes a weird little noise and I see nothing on the serial monitor.
Also it might be an issue of the USB cable which I will use another but it doesn't hurt posting my problem and asking for help.
Thanks!
I see one problem here. Please unplug the grove wire connected to the first socket. The ultrasonic sensor should be connected to the forth socket.
I also work on a Mac. The strange thing is that you can upload the code through the serial connection, and you can see the monitor prints out something with testServo. So the serial connection should be good. But when you upload writeInstinct.ino, nothing is printed.
How much memory is used according to the compiling information? Could you upload other small test sketches to see if the serial monitor prints out information?
As to the servos, you have to connect the 14500 3.7V Li-ion batteries to provide enough power.