I'm building the cat with my son as a father/son project and we're so close to finishing, but can't figure out the cable connections. I can't make heads or tails of attaching the wiring for the head or tail (or legs). I see lots of diagrams on the help forum that I can't understand. Is there a photo or diagram that says, "these prongs are where you attach the head" and "these prongs are where the left rear leg attaches"?
top of page
bottom of page
The gray numbers are unused joints on Nybble. You can find the board version to the left of the green power terminal. NyBoard V0_x.
That is VERY helpful, thanks! In the second diagram (the drawing), what's the difference between the red and gray numbers? Also, how can I tell if I have a V0_2 board?
Sorry for delayed response. Have you seen these pictures in the instruction doc?
The blocks on the belly refer to the 4x3 servo pins on the control board.
Pay attention to the servo's cable color. Brown is ground. If your board is V0_2, the brown cable should be closer the board.